Column Packing Reservoir
Downloads
Choice of Inlet Tubing Size and Reservoir Capacity
The modular design of the Column Packing Reservoir System gives you the options to suit your requirements. See Ordering information below for correct part numbers and quantities.
Modular Column Packing Reservoir System
SSI’s column packing reservoir system is specifically designed to provide fast, versatile, safe packing of efficient, reproducible columns. An internal baffle prevents the inlet flow stream from impinging directly on the slurry in the reservoir. A conical outlet section promotes smooth transfer of the slurry to the column. The quick-changed threaded reservoir closures help avoid slurry settling problems and promote more
reproducible packings.
The modular design allows fast interchange of reservoir housings and column connectors.
Knurled closure nuts and Kalrez® seals combine to allow fast, leak-tight changes to be made by hand -- no tools required. Although designed for long, reliable service, the seals can be quickly and easily replaced when necessary. The column couplings are drilled to allow direct contact of the column to a precolumn of the same diameter. This allows the
columns to be removed without disturbing the packing bed.
The system is designed for working pressures of 15,000 psi (103 Mpa). The threaded reservoir closures avoid the potential hazards of large compression fittings in high-pressure applications.
Reservoirs of 20, 40, and 80 mL are available with connections for 1/4” outside diameter columns. Adapters are available to accommodate special end fittings.
Ordering Information
A complete system requires one inlet cap, two knurled closure nuts, one reservoir, one outlet cap, and one drilled-through coupling.
- Choose one Inlet Cap (with nut, ferrule, and O-ring seal)
-- 1/16" inlet tubing…..010241
-- 1/4" inlet tubing…..010242
- Order 2 Knurled Closure Nuts (2 required)…..011185
- Specify Reservoir Capacity
-- 20 mL Reservoir…..011191
-- 40 mL Reservoir…..011192
-- 80 mL Reservoir…..011193
- Order one Outlet Cap (with CPI nut, ferrule, and O-ring seal)
-- 1/4" Column OD…..010228
- Order one Drilled-Through Coupling, 1/4"…..010122
Suggested Starting Conditions For Column Packing
